| 1. |
|
|
| 2. |
- Liu, Shaoteng, et al.
(författare)
-
A Fair and Maximal Allocator for Single-Cycle On-Chip Homogeneous Resource Allocation
- 2014
-
Ingår i: IEEE Transactions on Very Large Scale Integration (vlsi) Systems. - 1063-8210 .- 1557-9999. ; 23:10, s. 2229-2233
-
Tidskriftsartikel (refereegranskat)abstract
- Traditional allocators for network-on-chip (NoC) routers suffer from either poor-matching quality or limited fairness. We propose a waterfall (WTF) allocator targeting homogeneous resource allocation, which provides single-cycle maximal matching while guaranteeing strong fairness based on the round-robin principle. It can be implemented with a loop-free structure. In 90 nm technology, the allocator operates at about 1 GHz clock frequency. We compare WTF with wave-front, separable-input-first, and separable-output-first allocators and find that it is at least 10% smaller, has 50% less delay under high load, and uses 3% less power than any of these alternatives. Also, WTF is at least as fair or clearly fairer. We also find that in a 4 x 4 circuit switched NoC the use of WTF gives up to 20% higher network performance.
|
|
| 3. |
- Liu, Shaoteng, et al.
(författare)
-
Analysis and evaluation of circuit switched NoC and packet switched NoC
- 2013
-
Ingår i: Proceedings - 16th Euromicro Conference on Digital System Design, DSD 2013. - : IEEE. - 9780769550749 ; , s. 21-28
-
Konferensbidrag (refereegranskat)abstract
- Circuit switched NoC has, compared to packet switching, a longer setup time, guaranteed throughput and latency, higher clock frequency, lower HW complexity, and higher energy efficiency. Depending on packet size and throughput requirements they exhibit better or worse performance. In this paper we designed a circuit switched NoC and compared that with packet switched NoC. By speculation and analysis, we propose that, as packet size increases, performance decreases for packet switched NoC, while it increases for circuit switched NoC. By close examination on the router architecture, we suggest that circuit switched NoC can operate at a higher clock frequency than packet switched NoC, and thus at zero load above a certain packet size circuit switched NoC could be better than packet switched NoC in packet delay. Experiment results support our intuitions and analysis. We find the cross-over point, above which circuit switching has lower latency, is around 30 flits/packet under low load and 60-70 flits/packet under high network load.
|
|
| 4. |
- Liu, Shaoteng, et al.
(författare)
-
Highway in TDM NoCs
- 2015
-
Ingår i: Proceedings of the Ninth ACM/IEEE International Symposium on Networks-on-Chip (NoCS'15). - New York, NY, USA : ACM Digital Library. - 9781450333962
-
Konferensbidrag (refereegranskat)abstract
- TDM (Time Division Multiplexing) is a well-known technique to provide QoS guarantees in NoCs. However, unused time slots commonly exist in TDM NoCs. In the paper, we propose a TDM highway technique which can enhance the slot utilization of TDM NoCs. A TDM highway is an express TDM connection composed of special buffer queues, called highway channels (HWCs). It can enhance the throughput and reduce data transfer delay of the connection, while keeping the quality of service (QoS) guarantee on minimum bandwidth and in-order packet delivery. We have developed a dynamic and repetitive highway setup policy which has no dependency on particular TDM NoC techniques and no overhead on traffic flows. As a result, highways can be efficiently established and utilized in various TDM NoCs.According to our experiments, compared to a traditional TDM NoC, adding one HWC with two buffers to every input port of routers in an 8×8 mesh can reduce data delay by up to 80% and increase the maximum throughput by up to 310%. More improvements can be achieved by adding more HWCs per input per router, or more buffers per HWC. We also use a set of MPSoC application benchmarks to evaluate our highway technique. The experiment results suggest that with highway, we can reduce application run time up to 51%.
|
|
| 5. |
- Liu, Shaoteng, et al.
(författare)
-
MultiCS : Circuit switched NoC with multiple sub-networks and sub-channels
- 2015
-
Ingår i: Journal of systems architecture. - : Elsevier. - 1383-7621 .- 1873-6165.
-
Tidskriftsartikel (refereegranskat)abstract
- We propose a multi-channel and multi-network circuit switched NoC (MultiCS) with a probe searching setup method to explore different channel partitioning and configuration policies. Our design has a variable number of channels which can be configured either as sub-channels (spatial division multiplexing channels) or sub-networks. Packets can be delivered on an established connection with one or multiple channels. An adaptive channel allocation scheme, which determines a connection width according to the dynamic use of channels, can greatly reduce the delay, compared to a deterministic allocation scheme. However, the latter can offer exact connection width as requested. The benefits and burden of using different number of channels and configurations are studied by analysis and experiments. Our experimental results show that sub-network configurations are superior to sub-channel configurations in delay and throughput, when working at the highest clock frequency of each configuration. Under reasonable channel partitioning, sub-networks with narrow channels can generally achieve higher throughput than the network using single wide channels.
|
|
| 6. |
- Liu, Shaoteng, et al.
(författare)
-
Parallel probe based dynamic connection setup in TDM NoCs
- 2014
-
Konferensbidrag (refereegranskat)abstract
- We propose a Time-Division Multiplexing (TDM) based connection oriented NoC with a novel double time-wheel router architecture combined with a run-time parallel probing setup method. In comparison with traditional TDM connection setup methods, our design has the following advantages: (1) it allocates paths and time slots at run-time; (2) it is fast with predictable and bounded setup latency; (3) it avoids additional resources (no auxiliary network or central processor to find and manage connections); (4) it is fully distributed and therefore it scales nicely with network size. Compared to a packet based setup method, our probe based design can reduce path setup delay by 81% and increase network load by 110% in an 8×8 mesh, while avoiding the auxiliary network. Compared to a centralized method, our solution can double the success rate, while eliminating the central resource for path setup and reducing the wire overhead. Synthesis results suggest that our design is faster and smaller than all comparable solutions.
|
|
| 7. |
- Liu, Shaoteng, et al.
(författare)
-
Parallel Probing : Dynamic and constant time setup procedure in circuit switching NoC
- 2012
-
Ingår i: Design, Automation & Test in Europe Conference & Exhibition (DATE), 2012. - : IEEE Computer Society. - 9783981080186 ; , s. 1289-1294
-
Konferensbidrag (refereegranskat)abstract
- We propose a circuit switching Network-on-chip with a parallel probe searching setup method, which can search the entire network in constant time, only dependent on the network size but independent of the network load. Under a specific search policy, the setup procedure is guaranteed to terminate in time 3D+6 cycles, where D is the geometric distance between source and destination. If a path can be found, the method succeeds in 3D+6 cycles; if a path cannot be found, it fails in maximum 3D+6 cycles. Compared to previous work, our method can reduce the setup time and enhance the success rate of setups. Our experiments show that compared with a sequential probe searching method, this method can reduce the search time by up to 20%. Compared with a centralized channel allocator method, this method can enhance the success rate by up to 20%.
|
|
| 8. |
- Shaoteng, Liu, 1984-
(författare)
-
New circuit switching techniques in on-chip networks
- 2015
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Network on Chip (NoC) is proposed as a promising technology to address the communication challenges in deep sub-micron era. NoC brings network-based communication into the on-chip environment and tackles the problems like long wire complexities, bandwidth scaling and so on. After more than a decade's evolution and development, there are many NoC architectures and solutions available. Nevertheless, NoCs can be classi_ed into two categories: packet switched NoC and circuit switched NoC. In this thesis, targeting circuit switched NoC, we present our innovations and considerations on circuit switched NoCs in three areas, namely, connection setup method, time division multiplexing (TDM) technology and spatial division multiplexing (SDM) technology.Connection setup technique deeply inuences the architecture and performance of a circuit switched NoC, since circuit switched NoC requires to set up connections before launching data transfer. We propose a novel parallel probe based method for dynamic distributed connection setup. This setup method on one hand searches all the possible minimal paths in parallel. On the other hand, it also has a mechanism to reduce resource occupation during the path search process by reclaiming redundant paths. With this setup method, connections are more likely to be established because of the exploration on the path diversity.TDM based NoC constitutes a sub-category of circuit switched NoC. We propose a double time-wheel technique to facilitate a probe based connection setup in TDM NoCs. With this technique, path search algorithms used in connection setup are no longer limited to deterministic routing algorithms. Moreover, the hardware cost can be reduced, since setup requests and data flows can co-exist in one network. Apart from the double time-wheel technique for connection setup, we also propose a highway technique that can enhance the slot utilization during data transfer. This technique can accelerate the transfer of a data flow while maintaining the throughput guarantee and the packet order.SDM based NoC constitutes another sub-category of circuit switched NoC. SDM NoC can benefit from high clock frequency and simple synchronization efforts. To better support the dynamic connection setup in SDM NoCs, we design a single cycle allocator for channel allocation inside each router. This allocator can guarantee both strong fairness and maximal matching quality. We also build up a circuit switched NoC, which can support multiple channels and multiple networks, to study different ways of organizing channels and setting up connections. Finally, we make a comparison between circuit switched NoC and packet switched NoC. We show the strengths and weaknesses on each of them by analysis and evaluation.
|
|
